The Q Inflatable Seal and Clamp and Pneuma-Cel lines employ a universal air connector system. Connectors are most commonly located on the base of the profile, but, in the case of straight (as with Pneuma-Cel) or U-shaped configurations, can also be located out an end. Universal connectors cannot be located on the side of a profile. Depending on the width of the selected cross section, either a 10-32 or 1/8-27 NPT universal male fitting will be used. The following options are currently available within the Q Design Tool. These will be permanently affixed to the universal connector, so it's ready for immediate use.
| Small Width Profiles | Large Width Profiles | Description | |
| ACV1-1-100 | ACV3-1-100 | ||
|
|
 |
1/4" OD blue polyurethane hose, 18" long, no adapter. For use with EPDM, Nitrile, and Neoprene profiles | |
| ACV1-1-101 |
ACV3-1-101 |
||
 |
 |
1/4" OD blue polyurethane hose, 1/8-27 male NPT adapter (supplied loose). For use with EPDM, Nitrile, and Neoprene profiles | |
| ACV1-2-100 |
ACV3-2-100 |
||
 |
 |
1/4" OD clear high temp hose, 18" long, no adapter. For use with Silicone profiles | |
| ACV1-2-101 |
ACV3-2-101 |
||
 |
 |
1/4" OD clear high temp hose, 18" long, 1/8-27 male NPT adapter. For use with Silicone profiles | |
| ACV1-2-102 |
ACV3-2-102 |
||
 |
 |
1/4" OD clear high temp hose, 18" long, M8X1.0 male adapter. For use with Silicone profiles | |
| ACV1-3-102 |
ACV3-3-102 |
||
 |
 |
6mm OD green polyurethane air connector, M8X1.0 male adapter (supplied loose). For use with EPDM, Nitrile, and Neoprene profiles | |
| ACV1-4-100 |
ACV3-4-100 |
||
 |
 |
1/4" Direct Push Connect Adapter. For use with all materials |
