Energy Seals & Gaskets

Seals in Energy power plants require high levels of design competence and quality control. A willingness by the supplier to respond quickly to immediate needs is also a plus. At Pawling EP, we are equipped to handle these needs. Our energy seals typically consist of:

• Molded, fabric reinforced construction (rather than extruded) for close cross section tolerances, no after cure splice joints, and maximum structural integrity.
• Certified materials that have met the necessary radiation resistance testing. Contact Pawling EP for more information.
• All steps in engineering, manufacture, inspection and test are closely controlled by our nuclear quality-assurance program based on ANSI N45.2 and 10CFR50 Appendix B.

Fabric Reinforced Valve Seats Using our unique long press capabilities, Pawling EP manufactures an 8" (203 mm) wide, fully molded fabric reinforced natural rubber expansion joint in long continuous lengths used for large pipe assemblies in power plants. Diameters approaching 8-10 feet (2438 - 3048 mm) are not uncommon. Depending on the requirements, this part can either be molded and spliced endless or can be step-cured into a complete gasket.

Whatever your need for nuclear quality rubber seals and fabrications, contact us today. We can provide the answer with one of our many custom designs. Other products for which you may have need for are:

• Sheet/strip blow out panel seals
• Gaskets for manways, drain covers, etc.
• Filter system access door gaskets
• Washers and "O" rings inspection hatch seals
• Damper seal expansion joints
• Shield plug seals